Below are several examples of shadows found on the Snap Together style marquee that one of our competitors sells. I have been replacing these for customers for the last few months. After inspecting several, I spotted the fatal flaw in the design. With a few simple engineering advances, I was able to resolve this issue, […]
Read MoreThese instructions will help you install the Control Panel Light Switch Upgrade Kit. Step 1. Remove the control panel from your Arcade1up cabinet. Step 2. Locate the interface board and then locate the Power connector. The power connector is usually marked with the word “Power”. It should be a TWO PIN connector with RED & […]
Read MoreI have seen several of our competitor’s products installed on some Arcade1up machines, and all I can say is that I am horrified. The quality problems are visible without even looking very hard. Here are some horrific examples that I spotted in the last couple of days. They use cheap plexiglass, instead of polycarbonate. They […]
Read MorePeople ask why our marquees are better than the rest. There are many reasons, but here is one. Our marquee light is located on a bracket that is centered in the middle of the marquee and allows the LED’s to point directly at the marquee. This innovation eliminates the shadowing that occurs at the top […]
Read MoreHere are a couple pictures to explain why the lighted marquees installed on the Costco editions of Mortal Kombat II and Pac Man will not fit your Arcade1Up 1st Generation cabinets. In addition to the hole placement and space issues, the power connector is not standard, so you would have to replace the connector with […]
Read MoreDecember 31, 2018
Welcome to the Arcade Game Factory. Your home for arcade parts, artwork, clothing and much more! Keep checking back as we stock the Webstore with more goodies.
Read More